How to Clean Your Dryer Duct for Better Drying

Dryer

Within this article I am going to clarify the method that I use when cleaning one among my clients drier ducts. Some great benefits of the service is the air can move through the entire drier better making it possible for the dryer to function a lot more efficiently and saving money.

The first move is really to pull away the dryer away from the wallsocket. This makes it possible for you to access the gap in the wall which leads into the ducts. This is also a good time to eliminate the nozzle connecting the drier into the wall and also to wash out it too nicely.

The next move will be to decide whether the vent goes directly out or if it goes by way of the roof, or in the walls and out the face of your house. In case it is outside the negative, you should remove the pay when you can for an even broader cleanup electric dryer.

Today you are all set to wash. I personally use something called the Lint Eater which can be found at Lowes for $39. You may additionally will need to purchase some extensions to get an additional $20. The major kit only goes 12-feet. In case your duct is more than that, buy the extensions.

The apparel is a 4″ brush on 3′ sticks. There is an attachment which allows one to connect your store vac to the port while running the brush. I would suggest using it. To put a single 3′ rod using all the brush into the dryer duct at the walls . Next, join the vacuum attachment bit to the strand together with an rod poking throughout the small hole. Attach the vacuum and you’re ready to commence removing all of the accumulated dirt from in the ducts.

Work with a standard 3/8 drill and put the rod into the drill. Turn the vacuum on. Power up the drill and slowly and gradually move down the brush and forth at the vent. Then you switch off the drill, and insert a second 3′ pole section to the one in the vent. Gently conduct the now 6′ brush back and forth. Usually do not allow the rods to come straight back a lot out of this port while the brush is either tilted or the rods will spin up.

Keep on to bring the 3′ sections until you have reached the cap on the roofing or are simply outside your house. I usually test every so frequently if it moves out to observe much further I want to go. After verifying you have covered all of the vent, then take the drill off and clear away the brush and then rods.

Re-attach the vent hose into the dryer and the fins into your surface cap if taken out. Now your drier will run like new!

Leave a Reply

Your email address will not be published. Required fields are marked *